Fly-rod ‘actions’ – what do they mean?

by Bishfish on July 5, 2010

I guess one of the more confusing elements of fly-fishing is the hotchpotch of terms used to describe the “actions” of fly-rods. Hopefully I can dispel some of this confusion and help making a decision on what fly-rod to buy easier.eveningcast thumb Fly rod ‘actions’ – what do they mean?

Pared right down to basics, the term ‘action’ describes the way a rod bends. But don’t all rods bend the same way I hear you mutter? Well no, they don’t. It would all be very easy if rods bent in one constant arc from butt to tip (parabolic), but most don’t.

They don’t bend in a constant arc because a rod is tapered from butt to tip – the thin section of the rod near the tip bends much more than the thicker mid-section of the rod, which bends more than the butt section. Rod makers are able to control the ‘action’ of a rod, the way it bends and flexes, by making adjustments to the way the building material is laid-up.

A fly-rod has to perform two main functions, cast a fly-line and help land a fish once it is hooked. The casting action of the rod is the prime function, and should be seen as being way more important in freshwater trout fishing than its ability to help land fish… See the full article here
pixel Fly rod ‘actions’ – what do they mean?

Related posts:

  1. Do 10 foot light line-weight fly-rods make you a better angler?
  2. More Cheats and Fishing
  3. Fly Casting: Start Slow, Finish Fast, Stop Dead
  4. Military Secrets Help Produce the Ultimate Synthetic Fishing Rod
  5. New Method to Remove Line Twist On Land

Comments on this entry are closed.

Previous post:

Next post:


HomeAll Articles IndexTips1000+ Fishing QuotesAnswersBishMy BooksLinksSite Map
All Fly Fishing Articles IndexAll Saltwater Fishing Articles IndexAll General Fishing Articles IndexAll Tips Index